Products
News
-
Why does the Steel Bar Bend after being Cut by Flying She...
The quality of the bar 3# double-length flying shear is not good. After the cutting of flying shears, the tail of the steel bar has a bending of about 200MM. How can we solve this phenomenon? The flying shears cutting speed must be greater than the ...
MORE -
The Maintenance of Sizing Mill
S14 shaft gear bearing installation completed. S11 shaft bearing installation completed. S11 gear torque detection adjustment completed. s13 gear torque detection adjustment completed. s14 gear torque detection adju...
MORE -
What is Induction Furnace?
The induction furnace is an electric furnace that uses materials to induce electric heating effects to heat or melt materials. The main components of the induction furnace are sensors, furnaces, power supplies, capacitors and control systems. Under the acti...
MORE -
Development of High Speed Steel Rolls
High-carbon high-speed steel rolls (referred to as high-speed steel rolls) are the hottest roll materials with the shortest development time, the fastest development and the most promising applications. Since its inception in Japan in 1988, it has been wide...
MORE -
Characteristics of Morgan High Speed Wire Rod Mill
Characteristics of Morgan High Speed Wire Rod Mill The features of Morgan High Speed Wire Rod Mill are as follows: (1) By using MSNTC or automatic tension control system, looper regulator and main motor electronic control device, all sections of the...
MORE -
How Does a Blast Furnace Work?
The blast furnace is made of steel plate as the furnace shell, and the lining of the refractory brick is built in the shell. The blast furnace body is divided into five parts: the throat, the furnace body, the furnace waist, the belly, and the hearth...
MORE